Chapter 16. Tool Bar

QuickRevs provides a tool bar which can be be configured freely. Even user defined Tools and Checklists can be added to this tool bar.

Figure 16.1. Tool Bar

Tool Bar

  1. Open the tool bar configuration dialog
    To open the Tool Bar Configuration dialog press the ... button on the right side of the tool bar.

Figure 16.2. Tool Bar - configuration

Tool Bar - configuration

  1. Available tool bar items
    On the left side of the Tool Bar Configuration dialog all available items are listed. If Tools or Checklists are defined they are listed in this view as well.

  2. Selected tool bar items
    On the right side (Tool Bar Config tab) you can see and arrange the menu items which will be shown in the tool bar.

    [Note]Note
    The first four tool bar items are fixed and cannot be changed.

  3. Add / remove tool bar items
    To add tool bar items select one on the left side and use the add button (>). To remove a tool bar item select it on the right side and press the remove button (<). Use the remove all button (<<) to remove all selected tool bar items.

    [Note]Note
    Tools added to the tool bar, which are configured to be hidden in different review cycles, roles, phases, etc. will be hidden if this configuration dialog has been closed. These items will become visible if the options configured for these tools matches.

  4. Add separator / spacer and glue components
    Via the following buttons you can add additional components:
    | - adds a separator to the tool bar, depending on the used operating system this might be a vertically aligned dash or just some space between different menu items.
    - - adds a spacer to the tool bar, which puts some additional space between the tool bar items.
    <=> - the glue component moves all tool bar items before this component to the left of the tool bar and all others to the right. So you can align tool bar items at the right side. Only one glue component can be added.

    [Note]Note
    The separator (|) and spacer (-) component may look the same depending on the used operating system.

  5. Move tool bar items up / down
    Make use of the Up and Down buttons to move the selected menu items up or down.

  6. Reset all tool bar changes
    Restore Defaults resets all changes made for the tool bar configuration to its initial (default) state.

Figure 16.3. Tool Bar - configuration of menu items

Tool Bar - configuration of menu items

  1. Configure a tool bar item
    Make use of the options shown on the Menu Item Config tab to change a tool bar item. A tool bar item can be changed even if it is not shown in the tool bar. When a tool bar item is removed from the tool bar these changes are still saved.

  2. Restore a tool bar item
    Restore Defaults resets all changes made for this menu item to its default values.


Get QuickRev at SourceForge.net. Fast, secure and Free Open Source software downloadsCopyright 2008 - 2016 Tom SeidelLast Update: 2016-11-5